CHOOSING THE RIGHT PRESSURE TRANSMITTER FOR HAZARDOUS AREAS
Using electrical equipment in a hazardous location is a health and safety headache. Choosing the wrong pressure transmitter can cause problems, from simply wasting money to causing life threatening situations. So how do you confidently select the right pressure transmitter?
Hazardous Zones
First you need to understand hazardous locations. Explosive atmospheres can be caused by flammable gases, mists, vapours or combustible dusts. If there is enough of the substance mixed with the air, even the smallest of sparks could cause an explosion. The ATEX directive categorises hazardous areas like this:
• Zone 0/ 20 means that the area is constantly or often hazardous
• Zone 1/ 21 means that the area is occasionally hazardous
• Zone 2/ 22 means the area is rarely or temporarily hazardous
Many environments require intrinsic safety, but many transmitters may only be classed as explosion / flame proof or similar. There are many methods of protection that can be used to make a pressure transmitter safe in a hazardous area. Most will allow the sensor to be installed in areas classified as Zone 1 or 2. However, only intrinsically safe (ia) and encapsulated devices (m) can be used in Zone 0 locations.
At ESI we manufacture intrinsically safe pressure transmitters that are ATEX and IECEx certified. We are often asked for Explosion proof transmitters, but what are the differences?
The first and most notable difference is how the transmitters are built. An Ex-d pressure transmitter must have a flameproof or explosionproof enclosure. This means that the transmitter’s electronic components should be mounted inside a housing which is designed to contain the flame, should it explode or catch fire.
Intrinsically Safe (IS) describes a sensor that is designed and wired to work on such a low current and voltage that it cannot possibly ignite flammable material. Used together with an intrinsically safe isolated barrier, the transmitter can operate safely even in the most hazardous areas.
Wiring for hazardous areas
Explosion proof wiring is much more expensive than intrinsically safe wiring because it requires explosion proof conduit and seals to isolate the circuit from hazardous gases. The seals prevent the hazardous media from flowing into the conduit. If the circuit were to ignite any hazardous dusts or gases that made their way into the explosion proof wiring, the housing and conduit are capable of containing the explosion. Any escaping hot gases would be cooled enough so that they would not be able to ignite any of the hazardous media outside of the explosion proof conduit or fixtures.
Intrinsically safe wiring does not require the conduit and seals, but you will need an intrinsically safe barrier. This device is wired between the sensor and the power source. It controls the amount of energy that the power source sends to the sensor. Still unsure? We’re happy to help you select the best pressure transmitter for your hazardous application.
Contact sales on: +44 (0)1978 262255
